/
Suction cups 302

Suction cups 302

Feb 23, 2021


Note: The Suction cups slide on the square bars. There are 4 sets. They are attached with two 7/16" bolts

There is also an airline attached to each post

Step 1 - Loosen the two 7/16" bolts and move the suction cups to the desired location. Then retighten the bolts

Note: The Suction Cups should be placed about 1 inch from the top of the bag, and spread out evenly. See Diagram Below


DO NOT position the suction cups anywhere on the bottom turn over flap. You will not get enough vacuum for the suctions cups to properly hold the bag


If you run a 16" length bag or smaller you will need to remove the end Suction Cup. To remove the suctions cup use the 1/4" T wrench, loosen the bolt and remove. The bolt is in the center of the cup. Replace the bolt with the spare. DO NOT use the bolt that was just taken out

Move the shaft off to the side so it will not come down and hit the side rail

Looking for labels? They can now be found in the details panel on the floating action bar.

Related content

All content posted in our Confluence Spaces, including but not limited to text, images, videos, and audio files, are the exclusive property of Wisconsin Converting Inc. and are protected by U.S. and international copyright laws. Any reproduction, modification, distribution, or replication of our content without prior written permission from Wisconsin Converting Inc. is strictly prohibited.

All rights reserved. Wisconsin Converting Inc. reserves the right to take appropriate legal action against any unauthorized use of our content.